Download Multitech MTCMR-H User guide
Transcript
Chapter 3 – Supported GSM/WCDMA AT Commands +CMEE Report Mobile Equipment Errors Description: This command defines the method for returning error messages. The simple ERROR message can be replaced by the verbose method to include the results codes +CME ERROR: <err>. (See section "ME error result code: +CME ERROR" in the "Appendixes" of the present document for "+CME ERROR" result codes description. See section "Message service failure result code: +CMS ERROR" in the "Appendixes" of the present document for "+CMS ERROR" result codes). Syntax: Command Responses OK Action Command: AT+CMEE=<n> +CMEE: <n> Read Command: AT+CMEE? OK +CMEE: (list of supported <n>s) Test Command: AT+CMEE=? OK Values: <n> Error Reporting Method 0 Disable ME error reports; use only "ERROR. Default 1 Enable +CME ERROR: <err> or +CMS ERROR: <err> Parameter Storage: The <n> parameter is stored in EEPROM using AT&W command. The default value can be restored using AT&F. Examples: Command Responses AT+CMEE=? +CMEE: (0,1) OK AT+CMEE=0 OK Note: Disable ME error reports; use only "ERROR" AT+CMEE=1 OK Note: Enable "+CME ERROR: <err>" or "+CMS ERROR: <err>" AT+CMEE? +CMEE: 1 OK +CMER Mobile Equipment Event Reporting Description: This command enables or disables the sending of unsolicited result codes in the case of a key press. Syntax: Command Action Command: AT+CMER=[<mode>] [,[<keyp>] [,[<disp>] [, [<ind>] [,[<bfr>] ] ] ] ] Read Command: AT+CMER? Responses OK +CMER=<mode>,<keyp>,<disp>,<ind>, <bfr> OK Test Command: None Unsolicited Response:+CKEV: <key>, <press> (key press event report) +CIEV: <indresp>, <value> (indicator event report) High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A) 109