Download Multitech MTCMR-H User guide

Transcript
Chapter 3 – Supported GSM/WCDMA AT Commands
+ICF DTE-DCE Character Framing
Description:
This command determines the local serial port start-stop (asynchronous) character framing
used by the DCE.
Syntax:
Command
Action Command:
AT+ICF=<format>[,<parity>]
Read Command:
AT+ICF?
Test Command:
AT+ICF=?
Values:
Responses
OK
AT+ICF: <format>,<parity>
OK
AT+ICF: (list of supported <format>s),
(list of supported <parity>s)
OK
<format>
Character Framing Format
1 8 Data 2 Stop
<parity> parameter is ignored
2 8 Data 1 Parity 1 Stop
If no <parity> provided, 3 is used by default as <parity> value
3 8 Data 1 Stop
<parity> parameter is ignored. Default.
4 7 Data 2 Stop
<parity> parameter is ignored
5 7 Data 1 Parity 1 Stop
If no <parity> provided, 3 is used by default as <parity> value
6 7 Data 1 Stop
<parity> parameter is ignored
<parity>
Character Framing Parity
0 Odd
1 Even
2 Mark
3 Space
4 None. Default.
The <format> and <parity> parameters are stored in EEPROM using AT&W
command. The default value can be restored using AT&F.
Parameter Storage:
Examples:
Command
AT+ICF=?
AT+ICF=2,0
AT+ICF?
Notes:
Responses
+ICF: (1-6),(0-4)
OK
Note: Possible values
OK
Note: New values
+ICF: 2,0
OK
Note: Current values
All framing settings of the serial interface (i.e., 801, 8E1, 8S1, 8N1, 7N1, 7O1, 7E1, 7S1 and
7N2) are supported for autobaud mode.
If USB port is used:
• The action command is supported for compatibility reasons (but without effect).
• The response to the action command and the read command behavior is the
same as if sent on UART1 or UART2.
High Speed HSPA-H4 AT Commands Reference Guide (Document S000483A)
51