Download Comdial ExecuTech 0816 Series Specifications

Enter Bas.
;vel: Press ITCM, then dial N # 7 4 6 gc.
Master Clear: The entire
programming configuration as
discussed in the following
programming procedures, can be
defaulted to the factory settings all at
once using this master clear
Drocedure.
This programming action clears ail
memory en tries including any
previousiyprogrammedautodiai
numbers, and returns the system to
a stat-U default condition.
Press ITCM.
Dial + # 7 4 6 %.
Dial 15.
Press A12.
Dial 7051684.
Press % for base level
OR
Press MNTR (SPKR).
Pause Time: Durfng auto dials and
speed dials it is sometimes necessary
to delay the sending of digits to give
switching equipment time to prepare to
receive the digits. A pause can be
stored to effect the delay. A pause is
stored whenever the user presses the
HOLD button. The pause length
options are stored in seconds.
Dial 10.
Press prog. button.
Press * for next feature.
Pulse Dial Time: Either ten or twenty
pulses per second, and three different
make/break ratios for the pulse dialing
signals (rotary dial signals) can be set
to match CO requirements.
Dial 11.
Press prog. button.
Press *for next feature.
Recall/Flash: A line disconnect
[recall) or a PBX feature select signal
[flash) can be generated depending
upon the programmed time.
Dial 12.
Press prog. button.
Press * for next feature.
Timed Hold Recall: After a call has
been on hold for a programmed length
of time, the system will recall the
station that placed the call on hold.
The timing is in seconds.
Dial 13.
Press prog. button.
Press Q for next feature.
1 DEFAULT = 2.0 SEC.
I
Press t SPKR to end programming.