1
Download Enterasys RoamAbout 3000 Specifications
Transcript
Command Groups rts-threshold This command sets the packet size threshold at which a Request to Send (RTS) signal must be sent to the receiving station prior to the sending station starting communications. Syntax rts-threshold <threshold> threshold is the threshold packet size for which to send an RTS. Range: 0‐2347 bytes Default Setting 2347 Command Mode Interface Configuration (Wireless) Command Usage • If the threshold is set to 0, the access point never sends RTS signals. If set to 2347, the access point always sends RTS signals. If set to any other value, and the packet size equals or exceeds the RTS threshold, the RTS/CTS (Request to Send / Clear to Send) mechanism will be enabled. • The access point sends RTS frames to a receiving station to negotiate the sending of a data frame. After receiving an RTS frame, the station sends a CTS frame to notify the sending station that it can start sending data. • Access points contending for the wireless medium may not be aware of each other. The RTS/CTS mechanism can solve this “Hidden Node” problem. Example RoamAbout 3000#configure Enter configuration commands, one per line. End with CTRL/Z RoamAbout 3000(config)#interface wireless g Enter Wireless configuration commands, one per line. RoamAbout 3000(if-wireless g)#rts-threshold 256 RoamAbout 3000(if-wireless g)# RoamAbout Access Point 3000 Configuration Guide A-135
