Download Miele Excella G2732SCi Technical information

G1000 / G2000 Dishwashers
Technical Information
1.
2.
3.
4.
5.
6.
7.
Unscrew the water inlet mixer vent connection inside the cabinet.
Unscrew the salt container cap.
Remove the sealing ring.
Empty the salt container.
Close the opening with the service cap (available through Miele).
Unscrew the retaining nut.
Remove the left side panel (5.1.1).
Warning
Do not tilt the unit onto its right side, as this would cause water to
run into the fan.
8. Remove the drip pan (5.1.2).
9. Remove the heating relay from the water inlet mixer.
10. Place a cloth or towel under the plug connections between the water
inlet mixer and the water softener.
11. Disconnect the connection with hose clip to the water inlet mixer from the resin
chamber.
12. Disconnect all plug connections.
13. Remove the wiring harness from its guide.
14. Pull off the salt container downwards in the direction of its connection stub.
15. Close the connection stub on the salt container with the service stopper
(available through Miele).
16. Disconnect the connection with hose clip to the sump.
17. Pull the water inlet mixer out of the seal to the sump, tilt it to the side and remove
it.
Reassemble by following these instructions in reverse order. The following should
also be noted:
1. Pre-fit the vent screw on the water inlet mixer and apply soap solution to it as a
slip lubricant.
2. Apply soap solution to the O-rings as a slip lubricant and fit them on the water
inlet mixer stubs.
3. Refit the wiring harness in its guides on the salt container and water inlet mixer.
4.
Check all electrical components in the drip tray area for residual moisture.
Dry – as necessary.
Thoroughly remove any traces of salt / water that may have leaked.
After reassembly, fill the salt container with salt and water.
A short program, e.g. Quick wash 104°F, without load should be run to remove any
salt residues.Ensure all hardware is secured.
87