Download Satel INTEGRA Plus Specifications

74
Programming
SATEL
– encryption key (STATION KEY) and control panel identifier for the purposes of reporting
via Ethernet (ETHM KEY) if the SATEL format is selected,
– additional parameters if the SIA-IP format is selected,
– identifiers with which the events will be sent,
– event assignment (if STATION 1 AND 2 is selected);
– advanced options if SIA reporting format is selected.
4. If a reporting format other than CONTACT ID (FULL) or SIA (FULL) is selected:
– assign identifiers to the partitions, zones, keypads and expansion modules;
– program the codes for events which are to be reported.
5. Define the parameters of test transmissions.
9.2.3
GPRS reporting
As an external modem, the following module must be connected to the control panel
(the RS-232 ports of control panel and module must be connected):
 GSM LT-2 with firmware 2.11 (or later);
 GSM-4 with firmware 4.11 (or later);
 GSM-5.
If the GSM module is only connected to the control panel dialer terminals (TIP and
RING), the GPRS reporting settings will be ignored.
The EXTERNAL MODEM and MODEM ISDN/GSM/ETHM options must be enabled in the
control panel (see: section TELEPHONE OPTIONs p. 56).
The GPRS settings (APN, username, password, DNS server) must be programmed in
the GSM module.
1.
2.
3.
4.
5.
The TELIM format events cannot be sent using the GPRS technology.
Enable the REPORTING – GPRS option.
Determine whether the event codes will be sent to both monitoring stations or to one of
them only (STATION 1 OR 2 / STATION 1 / STATION 2 / STATION 1 AND 2).
Program the following for the monitoring station to which event codes are to be sent:
– reporting format in which the codes will be sent,
– server address,
– port number,
– IP format in which the codes will be sent (SATEL or SIA-IP),
– encryption key (STATION KEY) and control panel identifier for the purposes of GPRS
reporting (GPRS KEY) if the SATEL format is selected,
– additional parameters if the SIA-IP format is selected,
– identifiers with which the events will be sent,
– event assignment (if STATION 1 AND 2 is selected);
– advanced options if SIA reporting format is selected.
If a reporting format other than CONTACT ID (FULL) or SIA (FULL) is selected:
– assign identifiers to the partitions, zones, keypads and expansion modules;
– program the codes for events which are to be reported.
Define the parameters of test transmissions.