1
Download Agilent Technologies 1912A Technical data
Transcript
12 SYSTem Subsystem 1xeV-DO The following table shows the power meter presets when <character_data> is set to XEVDO. Commands not listed are preset according to their DEFault values (for further information refer to Table 12- 26). Table 12-57 1xeV-DO: Power Meter Presets Command Setting Comments +1900.000 MHz Frequency setting NORM Measurement mode E9321A/25A: DEF E9322A/26A: DEF E9323A/27A: HIGH N1921/2A: LOW Sensor video bandwidth [SENS[1]]|SENS2:SWE[1]|2|3|4 :OFF:TIME Gate 1: 10 µs Gates 2 - 4: 0 Delay between trigger point and time gated period. [SENS[1]]|SENS2:SWE[1]|2|3|4 :TIME Gate 1: 810 µs Gates 2 - 4: 0 Length of time gated period for time gated measurements. TRIG[:SEQ[1]|2]:SOUR INT1 INIT:CONT ON Trigger source set up and acquisition mode continuous triggering TRIG[:SEQ]:LEV:AUTO ON Enable automatic setting of the trigger level TRIG[:SEQ]:LEV AUTO Power level TRIG[:SEQ]:SLOP POS Trigger event recognized on the rising edge of a signal TRIG[:SEQ]:DEL 0s Delay between recognition of trigger event and start of a measurement TRIG[:SEQ]:HOLD 1 ms Trigger holdoff OFF Auto range off Frequency [SENS[1]]|SENS2:FREQ[:CW|:FIX] Sensor measurement mode [SENS[1]]|SENS2:DET:FUNC Sensor video bandwidth setup [SENS[1]]|SENS2:BAND|BWID:VID Gate Setup Trigger setup 1 Range [SENS[1]]|SENS2:POW:AC:RANG:AUTO 568 N1911A/1912A P-Series Power Meters Programming Guide
