Download SimPowerSystems User`s Guide
Transcript
Linear Transformer Winding 3 parameters The Winding 3 parameters parameter is not available if the Three windings transformer parameter is not selected. The nominal voltage in volts RMS (Vrms), resistance, and leakage inductance in p.u. The p.u. values are based on the nominal power Pn and on V3. Magnetization resistance and reactance The resistance and inductance simulating the core active and reactive losses, both in p.u. The p.u. values are based on the nominal power Pn and on V1. For example, to specify 0.2% of active and reactive core losses, at nominal voltage, use Rm = 500 p.u. and Lm = 500 p.u. Measurements Select Winding voltages to measure the voltage across the winding terminals of the Linear Transformer block. Select Winding currents to measure the current flowing through the windings of the Linear Transformer block. Select Magnetization current to measure the magnetization current of the Linear Transformer block. Select All voltages and currents to measure the winding voltages and currents plus the magnetization current. Place a Multimeter block in your model to display the selected measurements during the simulation. In the Available Measurements list box of the Multimeter block, the measurements are identified by a label followed by the block name. Measurement Label Winding voltages Uw1:, Uw2:, Uw3: Winding currents Iw1:, Iw2:, Iw3: Magnetization current Imag: 5-121
Related documents
LS 6000 Series Scintillation Systems Supplies & Accesories
ad2612 dvb ts scrambler user`s manual
manual
Développeur Informatique Web PHP
Oki MSM66207 User's Manual
Chapter 4 - Packt Publishing
LCGC 30(12) - LC Resources Inc.
1 GLIMMPSE 2.0.0* USER MANUAL Table of Contents 1
User Guide Version 6.1 - Opal-RT
VMware 5.8 User's Manual