Download PSC PT Program Generator User`s manual

2342.book Page 176 Thursday, July 22, 2004 8:35 AM
Troubleshooting
Error Message
Description
Error with <source file
name>
An error occurred while reading the source file. Make sure
you selected the correct source file. Open the file with PPG
and verify that it appears as expected. If the message persists, contact PSC Technical Support for assistance.
Your program may have too many nodes in a frame or have
too many fields defined in a template.
The application may be too large or complex for the available
memory in the compiler. Using PPG, modify your application
to make it smaller and try compiling again.
Language not supported
This version of PPGComp does not support the selected language. Contact PSC Technical support for assistance.
Syntax Error in <node
name>(line <line #>)
This message indicates an error in the source file. It usually
means that some required information is missing. Determine
which node is the problem, open the application with PPG,
locate the problem node and view its properties. Make sure
all required options are selected. Save the application and
select File->Download to compile and download the application.
PPGXfer Error Messages
Table 8. PPGXFER Error Messages
Error Messages
Description
The application is too big to be stored on the PDT. The downApplication is too large to
load cannot be completed. Using PPG, modify your applicaload, it must be < FFFFH.
tion to make it smaller and try downloading again.
176
Buffer allocation error
This error occurs when insufficient memory exists to run
PPGXfer. Close other applications and try again. If no other
applications are open, you may need to reboot your PC
before trying again.
Error opening hex file
This error indicates that the selected hex file could not be
opened. Make sure that the file exists and it is not currently
being used by another application
NAK received Re-sending.
This error indicates that PPGXfer received an unexpected
response from the PDT. PPGXfer will try again without any
further action from the user.
PT Program Generator (PPG) v5.0