Download Digital DEClaser 3500 Specifications
Transcript
Chapter 6: FRU Replacement and Fault Isolation Procedures 6.2.7 Paper Jam between Feeder and Reg. Sensor: Fault code E2 continued 9. PICK–UP SOLENOID ANALYSIS Use Diagnostic Tool test DG80 to check the Pick-up Solenoid. Open the Front Cover to observe the Pick–Up Solenoid. Does the Pick–Up Solenoid actuate? Yes No Go to Step 10 Go to Section 6.3.14 Pick–Up Solenoid Failure. 10. PICK–UP ROLL ASSEMBLY SOLENOID ANALYSIS Fill the Front Tray Assembly with paper. Use Diagnostic Tool test DG80, while DG90 MAIN MOTOR is running, to check the Pick–up Roll Assembly. Does the Pick–Up Roll and the Pick–Up Roll Cam make a complete revolution and pick up a single sheet of paper? Yes No Go to Step 11 Replace the Pick–up Roll Assembly. 11. BOTTOM PLATE ASSEMBLY ANALYSIS Fill the Front Tray Assembly with paper. Use Diagnostic Tool test DG80, while DG90 MAIN MOTOR is running, to check the Bottom Plate Assembly. Does the Bottom Plate Assembly press against the Pick–Up Roll when the Pick–Up Roll Cam disengages? Yes No Go to Step 12. Replace the Bottom Plate Assembly. 12. RETARD PAD ASSEMBLY ANALYSIS Open the Front Transport Assembly. Rotate the Pick–Up Roll until it touches the Retard Pad Assembly. Close the Front Transport Assembly. Observe the Retard Pad through the Front Tray Assembly opening. Does the Retard Pad Assembly touch the Pick–Up Roll? Yes No Go to Step 23. Replace the Lower Chute Assembly. 6-15
Related documents
Digital DEClaser 3500 User`s guide
Digital Equipment Corporation DEClaser 3500 Installation guide
Digital DEClaser 3500 Installation guide
Télécharger le fichier
Digital Equipment Corporation DEClaser 5100 User`s guide
Digital DEClaser 3500 Installation guide
Software- Produktbeschreibung - Hewlett
Digital Equipment Corporation DECcolorwriter 1000 Technical data
Digital Equipment Corporation DEClaser 3250 Technical data
DCPS V2.0 User`s Guide