Download Digital DEClaser 3500 Specifications
Transcript
Chapter 10: Removal and Replacement Procedures --- Feeder Assembly RRP 2.7 No-Paper Actuator NOTE: If this printer has an optional Feeder Assembly, remove it before starting this RRP. Removal 1. Remove the Paper Cassette. 2. Remove the Feeder Assembly (RRP 2.1). 3. Remove the two tapped 8mm gold screws securing the Feeder Tie Plate. 4. Remove the plate. 5. Remove the five screws (two 8mm silver screws on top, and three tapped 8mm silver screws on the bottom) securing the Feed Housing R. 6. Remove the Feed Housing R. 7. Rotate the No-Paper Actuator counter clockwise to the position shown in the illustration . 8. Remove the No-Paper Actuator from the Feeder Frame Assembly. Replacement 1. Slide the small end of the No-Paper Actuator into the hole in the tab at the center of the Feeder Assembly. 2. Rotate the No-Paper Actuator counter clockwise to the position shown in the illustration. 3. Rotate the No-Paper Actuator clockwise. Make sure it clears the sensor on the Feeder PWB. 4. Reinstall the Feed Housing R. Secure it with two 8mm silver screws on top, and three tapped 8mm silver screws on the bottom. 5. Position the Feeder Tie Plate. Secure it with two 8mm tapped gold screws. 10-15
Related documents
Digital DEClaser 3500 User`s guide
Digital Equipment Corporation DEClaser 3500 Installation guide
Digital DEClaser 3500 Installation guide
Télécharger le fichier
Digital Equipment Corporation DEClaser 5100 User`s guide
Digital DEClaser 3500 Installation guide
Software- Produktbeschreibung - Hewlett
Digital Equipment Corporation DECcolorwriter 1000 Technical data
Digital Equipment Corporation DEClaser 3250 Technical data
DCPS V2.0 User`s Guide