Download Compaq HSG80 - StorageWorks RAID Array Controller Specifications

7–97
NODE_ID=nnnn-nnnn-nnnn-nnnn checksum
Sets the subsystem worldwide name (node ID). If a situation occurs that requires you
to reset the subsystem worldwide ID (node ID), use the name and checksum that
appear on the sticker on the frame into which your controller is inserted.
CAUTION: Each subsystem has its own unique worldwide name
(node ID). If you attempt to set the subsystem worldwide name to a
name other than the one that came with the subsystem, the data on the
subsystem will not be accessible. Never set two subsystems to the
same worldwide name; data corruption will occur.
PORT_1_AL_PA=
PORT_2_AL_PA=
Used only in arbitrated loop (FC-AL) topology.
Specifies the hexadecimal arbitrated loop physical address (ALPA) for the host ports.
Use this switch only when LOOP_HARD is specified for PORT_1_TOPOLOGY or
PORT_2_TOPOLOGY. The range of addresses allowed is 0-EF (hexadecimal). The
default value is 69.
PORT_1_TOPOLOGY=LOOP_HARD
PORT_1_TOPOLOGY=LOOP_SOFT
PORT_1_TOPOLOGY=OFFLINE
PORT_2_TOPOLOGY=LOOP_HARD
PORT_2_TOPOLOGY=LOOP_SOFT
PORT_2_TOPOLOGY=OFFLINE
Used only in arbitrated loop (FC-AL) topology.
Indicates whether the user or controller selects the ALPA for a host port, or whether
the port is to be set offline. LOOP_HARD allows you to pick the ALPA.
LOOP_SOFT requests the controller to pick the ALPA. OFFLINE sets the host port
offline. Specify OFFLINE for a port when it will not be used.
Compaq HSG80 Array Controller ACS Version 8.4 Configuration and CLI Reference Guide