Download Cisco Engine 611 Specifications

Transcript
Chapter 3 CLI Commands
(config) authentication
Note
Authorization privileges apply to console and Telnet connection attempts, secure FTP (SFTP)
sessions, and Secure Shell (SSH, Version 1 and Version 2) sessions.
We strongly recommend that you set the administrative login authentication and authorization
methods in the same order. For example, configure the WAAS device to use RADIUS as the
primary login method, TACACS+ as the secondary login method, Windows as the tertiary
method, and the local method as the quaternary method for both administrative login
authentication and authorization.
In the following example, RADIUS is specified as the primary method, TACACS+ as the secondary
method, Windows as the third method, and the local database as the fourth method. In this example, four
login authorization (configuration) methods are specified because the fail-over server-unreachable
feature is not enabled on the WAAS device.
WAE(config)#
WAE(config)#
WAE(config)#
WAE(config)#
Note
authentication
authentication
authentication
authentication
configuration
configuration
configuration
configuration
radius enable primary
tacacs enable secondary
windows-domain enable tertiary
local enable quaternary
If you have enabled the failover server unreachable feature on the WAAS device, make sure that
you specify either TACACS+ or RADIUS as the primary scheme for authorization
(configuration), and specify local as the secondary scheme for authorization (configuration).
The following example shows the resulting output of the show authentication command:
WAE# show authentication user
Login Authentication:
Console/Telnet/Ftp/SSH Session
----------------------------- -----------------------------local
enabled (primary)
Windows domain
enabled
Radius
disabled
Tacacs+
disabled
Configuration Authentication:
----------------------------local
Radius
Tacacs+
Related Commands
Console/Telnet/Ftp/SSH Session
-----------------------------enabled (primary)
disabled
disabled
(config) radius-server
show authentication
show statistics radius
show statistics tacacs
(config) tacacs
windows-domain
(config) windows-domain
Cisco Wide Area Application Services Command Reference
3-264
OL-11817-01