Download Siemens RUGGEDCOM RSG2200 User guide

Transcript
RUGGEDCOM ROS
Chapter 5
User Guide
Parameter
Setup and Configuration
Description
For an incoming TCP connection (server), the local interface IP address on which to
listen for connection requests. An empty string implies the default: the IP address of the
management interface.
When both outgoing and incoming connections are enabled (client or server), this is the
remote IP address to which to place an outgoing TCP connection request or from which
to accept an incoming request.
Link Stats
Synopsis: { Disabled, Enabled }
Default: Enabled
Enables link statistics collection for this protocol.
5.
Click Apply.
Section 5.4.15
Configuring the Telnet Com Port Protocol
To configure the Telnet Com Port protocol for a serial port, do the following:
1.
Make sure the serial port is configured to use the Telnet Com Port protocol. For more information, refer to
Section 5.4.5, “Configuring a Serial Port”.
2.
Navigate to Serial Protocols » Configure Protocols » Configure Telnet Com Port. The Telnet Com Port
table appears.
Figure 99: Telnet Com Port Table
3.
Select a serial port. The Telnet Com Port form appears.
Configuring the Telnet Com Port Protocol
143