Download Siemens RUGGEDCOM RSG2200 User guide

Transcript
Chapter 5
RUGGEDCOM ROS
Setup and Configuration
User Guide
Figure 101: Remote Table
If remote hosts have not been configured, add hosts as needed. For more information, refer to Section 5.4.16.2,
“Adding a Remote Host”.
Section 5.4.16.2
Adding a Remote Host
To add a remote host for the Raw socket protocol, do the following:
1.
Navigate to Serial Protocols » Configure Protocols » Configure Raw Socket » Configure Remote
Hosts. The Remote Hosts table appears.
Figure 102: Remote Table
2.
Click InsertRecord. The Remote Hosts form appears.
1
2
3
4
6
5
Figure 103: Remote Hosts Form
1. IP Address Box
3.
146
2. IP Port Box
3. Port(s) Box
4. Apply Button
5. Delete Button
6. Reload Button
Configure the following parameter(s) as required:
Adding a Remote Host