Download VODVRHD5014 User manual

VODVRHD5014 User’s Guide
7.1.1 CONNECT TO WEB SERVER
Enter the IP address of DVR into the ULR bar referring to the below picture.
NOTE) You can know the IP address of DVR from the ‘INFO’ section under the OPERATION
SETUP of DVR menu. If the local IP which starts with ‘192.168.xxx.xxx’ is used in the DVR,
you have to set the ‘Port Forwarding’ properly in your router. The port number to set can
be get from ‘DVR PORT’ in the NETWORK SETUP. If your router supports the ‘uPNP’ feature,
there is no need to set ‘Port Forwarding’ manually because the DVR supports the ‘Auto
Port Forwarding’ function using the ‘uPNP’ protocol. (Some routers can make the
compatibility issues to the uPNP protocol of DVR)
NOTE) If the access to the web server can’t be established after setting the ‘Port
Forwarding’, you may need to check the firewall of router and your PC. The port used in
the DVR should be allowed to access by the firewall.
[The initial screen of Web Server]
1: Enter the IP address of your DVR. If you don’t use the default port number of HTTP, 80, you
may add the port number following the IP address. Ex. http://192.168.123.63:80
2: Input the adminstrator’s password beside of the ‘ADMIN PASSWORD’. Only admistrator
can log in for the DVR configuration. Clikcing the ‘LOGIN’ button will guide you to the DVR
configuration pages.
3: ActiveX based Web Viewer: Clicking the link execute the ‘WebViewer’ or initiate the
installation of ActiveX plugin.
53