Download 1394 - Artisan Technology Group
Transcript
Using the Human Interface Module (HIM) C-3 The keys that are available for use on the HIM are described below: Note: The keys that are not described (shaded in Figure C.2) are not currently used. Escape When you press the ESC key, the programming system goes back one level in the menu tree. Select When you press the SEL key the cursor move alternately to the top or bottom line of the display thereby activating that portion of the display. The flashing first character indicates which line is active. Increment/Decrement These keys increment and decrement a value or scroll through different groups or parameters. Enter When you press the enter key, a group or parameter is selected or a parameter value is entered into memory. After a parameter has been entered into memory, the top line of the display will automatically become active, allowing you to choose another parameter or group. Start If hardware is enabled and no other control devices are sending a Stop command, Start initiates drive operation (default setting). To change this function, you need to reconfigure the [Command Mask] and [Typ 1 Logic Axis] parameters. Refer to the Configuring Your 1394 Analog Servo System chapter. ! ATTENTION: To avoid personal injury or damage to equipment, you must supply a 24V DC enable signal to the axis that is in START mode. Stop When you press STOP, a stop sequence is initiated at the System Module causing a controlled stop to be initiated in each axis, as determined by [Stop Mode], [Stop Time Lim] and [Stopping Cur]. Refer to the Configuring Your 1394 Analog Servo System chapter for more information. STOP can also be used to clear some fault messages after the condition that caused the fault is corrected. Publication 1394-5.0 — May 2000 Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com