Download M2000C RS232 Configuration

Table of Contents
1
2
3
4
Preface.......................................................................................................................................... 3
Installation.................................................................................................................................... 4
RS232 Configuration ................................................................................................................... 5
Configuring the Parameters ......................................................................................................... 6
4.1
System Parameters ...............................................................................................................6
4.1.1
System Parameters (Next)............................................................................................6
4.1.2
Save PROM (Act) ........................................................................................................6
4.1.3
RS485 baud rate (1200 to 9600) ..................................................................................6
4.1.4
Address (1 to 62)..........................................................................................................6
4.1.5
Special programme (0 to x)..........................................................................................6
4.1.6
Factory default PROM (Act)........................................................................................6
4.1.7
Read config. (Act)........................................................................................................7
4.1.8
Load config. (Act)......................................................................................................12
4.2
Programming Switches ......................................................................................................14
4.2.1
Programming switches (Next) ...................................................................................15
4.2.2
Save PROM (Act) ......................................................................................................15
4.2.3
Start attempts (1 to 255).............................................................................................15
4.2.4
Crank time (1 to 255) .................................................................................................15
4.2.5
Rest time (1 to 255)....................................................................................................15
4.2.6
Start delay (1 to 255)..................................................................................................15
4.2.7
Stop time (1 to 255) ...................................................................................................15
4.2.8
C/B trip (0 to 255)......................................................................................................16
4.2.9
Cool down (0 to 255) .................................................................................................16
4.2.10
Lube pump (0 to 255).................................................................................................16
4.2.11
Protec. on (1 to 255)...................................................................................................16
4.2.12
Frequencies ................................................................................................................16
4.2.13
Nominal frequency (50 to 9999)................................................................................16
4.3
Special Outputs ..................................................................................................................17
4.3.1
Special outputs (Next)................................................................................................17
4.3.2
Save PROM (Act) ......................................................................................................17
4.3.3
Set a special output (Off/On) .....................................................................................17
4.4
RS485 Request...................................................................................................................18
4.4.1
RS485 request (Next).................................................................................................18
4.4.2
Save PROM (Act) ......................................................................................................18
4.4.3
Change a request state (Off/On).................................................................................18
4.5
Prealam Settings.................................................................................................................19
4.5.1
Prealarm settings (Next).............................................................................................19
4.5.2
Save PROM (Act) ......................................................................................................19
4.5.3
Alarm delay (1 to 255) ...............................................................................................20
4.5.4
Change a prealarm setting (Off/On)...........................................................................20
4.5.5
Test OVS 100%, input 10 (Off/On) ...........................................................................20