Download Foreword

WIN-9_F Series User Manual
· Terminal S3 function: set to P036
· Terminal S4 function: set to P037
· Terminal S5 function: set to P038
· Terminal S6 function: set to P039
Setting
Name
Description
0
REV run command (2-wire sequence)
1
FWD/REV run command(3-wire sequence)
Only parameter P035 can be set to this value.
2
External fault (NO contact input)
3
External fault (NC contact input)
Inverter stops at fault when external fault signal is
input. Digital operator displays “EF0”.
4
Fault reset
Resets fault. Fault reset is disabled during run command input.
5
LOCAL/REMOTE selection
-
6
Serial communication/control circuit
terminal selection
-
7
Fast stop
Decelerates to stop by decel time 2 (P022) when fast
stop is input.
8
Master frequency reference inputselection level selection
Master frequency reference input level (voltage input
at“open”current input at“closed”) can be selected.
9
Multi-step speed reference 1
10
Multi-step speed reference 2
11
Jog frequency selection
12
Accel/decel time selection
13
External baseblock (NO contact input)
14
External baseblock (NC contact input)
Coasting signal. Motor starts coasting when the signal
Digital operator displays “bb” (blinking).
15
Search command from maximum frequency
Speed search command signals.
16
Search command from set frequency
17
Constant setting enable/disable
18
PID integral value reset
19
PID control disable
20
Timer function
-
21
OH3 (inverter overheat alarm)
When this signal is input, the digital opertor displays
“OH3” (blinking). Inverter continues operation.
22
Analog reference sample/hold
Analog frequency reference is sampled at closed and
held at open.
25
UP/DOWN command
Only parameter P039 can be set to this value.
26
Loop test
Only parameter P039 can be set to this value.
-
Permission or prohibition of constant setting from the
digital operator or serial communication (setting disabled at“closed”, enabled at“open”) can be selected.
-
●
62
●