Download COM Express Mini Module User`s Manual

Chapter 3
7. Use the long mounting screws to secure the heat sink on the top of the COM Express Mini
module and the COMe-LINK2 debug card and connect the cooling fan’s cable to the fan
connector on the COM Express Mini module. The photo below shows the locations of long
mounting screws.
5. Grasp the COM Express Mini module by its edges to press it down on the top of the
COMe-LINK2 debug card.
Cable
COM Express Mini Module
Long screws
COMe-LINK2
COMe-DEBUG
6. Then, grasp the heat sink by its edges and position it down firmly on the top of the
COM Express Mini module.
Cable
Carrier Board
COM Express Mini Module
COMe-LINK2
Side View of the Module, Debug Card and Carrier Board
COMe-DEBUG
25
Chapter 3 Hardware Installation
www.dfi.com