Download PDF file

$!LINEARINTERPOLATE
Description:
A SetValue command that sets some of the internal limits in Tecplot. See Tecplot User’s
Manual for the default values for these limits. The $!LIMITS command can only be
used in the Tecplot configuration file.
Optional Parameters:
Parameter
Syntax
LODThresholdMinFract
LODThresholdMaxFract
MAXAVAILABLEPROCESSORS
<op> <double>
<op> <double>
<op> <integer>
MAXPTSINALINE
MAXCHRSINTEXTLABELS
MAXNUMCONTOURLEVELS
MAXPREPLOTVARS
<op>
<op>
<op>
<op>
MAXPREPLOTZONES
<op> <integer>
MAXNUMPICKOBJECTS
MAXTHREADS
MAXUSABLEMEMORY
<op> <integer>
<op> <integer>
<op> <integer>
Example:
<integer>
<integer>
<integer>
<integer>
Notes
Sets the maximum number of processors used by Tecplot.
Some tasks can be performed in parallel so using all
available processors can greatly increases performance of
those tasks. A value of zero instructs Tecplot to use the
maximum number of processors available on the machine up
to the limit of 8 and provides the best performance in most
cases. Values between 1 and 8 can be assigned to override
what Tecplot thinks is the maximum number or to limit the
number of processors used by Tecplot.
Maximum number of points for geometry polylines.
Maximum number of characters in text labels.
Maximum number of contour levels.
Maximum number of variables allowed in an ASCII data file
loaded into Tecplot.
Maximum number of zones allowed in an ASCII data file
loaded into Tecplot.
Maximum number of objects to pick.
Limit the number of threads
Limit the amount of memory used by Tecplot.
Increase the maximum number of contour levels allowed to 1,000:
$!LIMITS
MAXNUMCONTOURLEVELS = 1000
$!LINEARINTERPOLATE
Syntax:
$!LINEARINTERPOLATE
DESTINATIONZONE = <integer>
[optional parameters]
Description:
Interpolate selected variables from a set of source zones to a destination zone using linear
interpolation. The source zones cannot be I-ordered. Values assigned to the destination
zone are equivalent to the results of using the probe tool in Tecplot.
Required Parameter:
Parameters
Syntax
DESTINATIONZONE
= <integer>
Notes
Zone to interpolate to.
161