Download Technical Manual
Transcript
EN R14.13.M USER INSTRUCTIONS AND MAINTENANCE ALARM SETTING PARAMETERS (P) Display indication P01 Flow switch alarm delay when starting the pump 20,0 P02 Flow switch alarm delay during steady operation P03 Low pressure alarm delay at compressor start-up Parameter and Description Default Factory U.M. Level 20,0 sec -U- 05 05 sec -U- 40,0 40,0 sec -U- 00 / flag -U- Enable compressor capacity-control with high pressure 0= capacity control deactivated P04 1= capacity-control with high pressure active 2= capacity-control with low pressure active 3= capacity-control with high and low pressure active P16 High temperature alarm set point 80,0 / °C -U- P17 High temperature alarm delay at start-up 30,0 / °C -U- P18 High pressure alarm set from transducer 20,0 41,0 bar -F- P19 System low temperature alarm set point 10,0 6,0 °C -U- P20 Alarm relay output logic 0,0 / flag -U- P22 Low pressure alarm delay at start-up compressor in heat pump 40,0 / sec -U- P23 Low pressure alarm delay at compressor start-up in defrost 40,0 / sec -U- 44