Download Technical Manual

Transcript
EN R14.13.M
USER INSTRUCTIONS AND MAINTENANCE
ALARM SETTING PARAMETERS (P)
Display
indication
P01
Flow switch alarm delay when starting the pump
20,0
P02
Flow switch alarm delay during steady operation
P03
Low pressure alarm delay at compressor start-up
Parameter and Description
Default Factory
U.M.
Level
20,0
sec
-U-
05
05
sec
-U-
40,0
40,0
sec
-U-
00
/
flag
-U-
Enable compressor capacity-control with high
pressure
0= capacity control deactivated
P04
1= capacity-control with high pressure active
2= capacity-control with low pressure active
3= capacity-control with high and low pressure active
P16
High temperature alarm set point
80,0
/
°C
-U-
P17
High temperature alarm delay at start-up
30,0
/
°C
-U-
P18
High pressure alarm set from transducer
20,0
41,0
bar
-F-
P19
System low temperature alarm set point
10,0
6,0
°C
-U-
P20
Alarm relay output logic
0,0
/
flag
-U-
P22
Low pressure alarm delay at start-up compressor in
heat pump
40,0
/
sec
-U-
P23
Low pressure alarm delay at compressor start-up in
defrost
40,0
/
sec
-U-
44