Download Trillium Seismometer User Guide
Transcript
Chapter 2: Preparation ing, and a continuous outer shield provides good high-frequency RF shielding. The outer shield should be earthed at the digitiser for safety. The digital ground (DGND) must be used for the return currents of the control signals (CAL_SIG, U_CALEN, V_CALEN, W_CALEN, UVW and ACC). Note that the analog ground (AGND) is connected to chassis ground (CHGND) inside Trillium, so if these signals are already connected at the digitiser, AGND should not be connected through the cable or else a ground loop will be created. 13912R10 2004-07-14 Trillium Seismometer User Guide 5