Download Trillium Seismometer User Guide

Transcript
Chapter 2: Preparation
ing, and a continuous outer shield provides good high-frequency RF shielding. The
outer shield should be earthed at the digitiser for safety.
The digital ground (DGND) must be used for the return currents of the control signals
(CAL_SIG, U_CALEN, V_CALEN, W_CALEN, UVW and ACC). Note that the analog ground (AGND) is connected to chassis ground (CHGND) inside Trillium, so if
these signals are already connected at the digitiser, AGND should not be connected
through the cable or else a ground loop will be created.
13912R10
2004-07-14
Trillium Seismometer
User Guide
5