1
Download Vector Measuring System USERS MANUAL
Transcript
VECTOR USERS MANUAL Optional Upper Body Bar (continued)......... To install the Upper Body Bar, attach one of the Vertical Scales to Upper Bar and place assembly’s pointers on reference points. (See Figure 28.) Then tighten Pointer Housings (see Figure 29); however, if a reference point appears to be misaligned, do not tighten its Pointer Housing. Next, install Lower Bar (with three Targets installed) and remaining Vertical Scale. If needed, adjust height of Lower Bar to enable Body Scanner to view all three Targets. IMPORTANT: 1) Target Number 45 must be in center of Lower Bar and Target Numbers 43 and 44 must be under their respective Pointers. (See Figure 30.) 2) Body Scanner’s Lasers should strike near center of Target faces. 3) Length of Vertical Scales must be equal, one side of vehicle to the other. Figure 28 Figure 29 Figure 30 15
