Download DAMATIC I/O Server

Transcript
Klinkmann Automation DAMATIC I/O Server
7
Configuring the DAMATIC I/O Server
After the DAMATIC I/O Server is initially installed, a small amount of configuration is
required. Configuring the Server automatically creates a DAMATIC.CFG file which holds
all of the topic definitions entered, as well as the configuration of sockets. This file will
automatically be placed in the same directory in which DAMATIC.EXE is located unless
the path where the configuration file will be placed is a specified via the /Configure/Server
Settings... command.
To access the commands used for the various configurations, open the /Configure menu:
Server Settings Command
A number of parameters that control the internal operation of the Server can be set. In
most cases, the default settings for these parameters provide a good performance and
do not require changing. However, they can be changed to fine-tune the Server for a
specific environment.
To change the Server's internal parameters, invoke the Configure/Server Settings...
command. The "Server Settings" dialog box will appear:
The following describes each field in this dialog box:
Protocol Timer Tick
This field is used to change the frequency at which the Server checks for data to process.
This frequency real value depends on total amount of data the Server is requesting from
the Damatic XD system. The desired Protocol Timer Tick value must be enough to
allow process all requests at the shortest time desired to update data from the Damatic
XD system. The default value is 50 milliseconds.
DAMATIC I/O Server Ver 2.x User Manual Rev 2.8
090XXM28.PDF