Download Chapter 6 Advanced Operation

Chapter 7
Parameter Lists
Sequence for Reference: d4
Para
meter
No.
d4-01
Name
Setting
range
Default
setting
Reference
frequency
hold
function
selection
Sets whether or not frequencies
on hold will be recorded.
0: Disabled (when operation is
stopped or the power is
turned on again starts at 0.)
1: Enabled (when operation is
stopped or the power is
turned on again starts at the
previous hold frequency.)
Note: This function is available
when the multi-function
inputs “accel/decel Ramp
Hold” or “UP/DOWN”
commands (MOP
increase/decrease) are
set.
0, 1
Trim control
level
Sets the increase/decrease
frequency for analog frequency
references as a percentage of
the maximum frequency.
Note: This function is available
when the multi-function
inputs “Trim Ctl Increase”
or “Trim Ctl Decrease” is
set.
Trim
Control Lvl
Control mode
0
Changes
during
operation
NO
A
0 to
100
25
NO
A
Setting
range
Default
setting
0: Speed control (C5-01 to
C5-07)
1: Torque control
Note: This function is only available in flux vector control
mode.
To use the function for
switching between speed
and torque control, set to
0 and set the multi-function input to “speed/torque
control change.”
0, 1
0
Changes
during
operation
NO
X
Sets the torque reference delay
time in ms units.
Note: This function can be used
to adjust the noise of the
torque control signal or
the responsiveness with
the host controller. When
vibration occurs during
torque control, increase
the set value.
0 to
1000
0
NO
X
Display
name
MOP Ref
Memory
d4-02
Description
V/f
control
V/f
with
PG
Page
Open
loop
vector
Flux
vector
A
A
A
6-65
A
A
A
6-66
Torque Control: d5
Para
meter
No.
d5-01
Name
Torque control selection
Torq Control Sel
d5-02
Description
Display
name
Torque reference
delay time
Torq Ref
Filter
Control mode
V/f
control
V/f
with
PG
Page
Open
loop
vector
Flux
vector
X
X
A
6-20,
6-27
X
X
A
6-25
7-23