Download RT-300 User Manual

Transcript
Operating Manual
Bearing System RT 300
3.1.3 LC -Graphic-Display
The centered LC-Display is showing all relevant bearing data, adjustments and status
reports. Background brightness may be adjusted in menu: LIGHT\DIM LCD BACKL,
contrast in menu: LIGHT\LCD CONTRAST.
When adjusting, the range of adjustment will be displayed as well as the active keys and
their function.
In menu-mode all selecting fields and adjustments are displayed.
In bearing-mode the graphic display is divided into following fields:
3.1.4 Digital Bearing-value Display
Receiving a bearable signal, the
Indicating 28 secs
bearing value will appear in the
since last bearing
display`s lower left area with a
resolution of 1°. If there is no more
signal available, the display will start flashing for a certain
time, alternately showing in the display „LAST“ (adjustable in
menu: SETUP\ BEARING\ LAST_TIME). After that the
information, „last bearing“ will be shown for 10 min., indicating
the duration since the last bearing.
After 10 min without signal three dashes are displayed.
Fig. 8
Fig. 9
3.1.5 Direction of reference
The selected direction of referencce is displayed left of the
digital bearing value. Following directions of reference may be
selected:
Fig. 10
Display
REL
MAG
Direction of reference
relative
magnetic Nord
TRU
true (geographic) North
Remarks
bearing relative to longitudinal axis of antenna (North – South)
bearing relative to magnetic North
 optional internal compass module required or
 compass information via NMEA interface required, input of
variation(see 3.3.2.5.4.5.3)
bearing relative to geographic North
optional internal compass module required or
 compass information via NMEA interface required, input of
variation(see 3.3.2.5.4.5.3)
Issue: 2013/03/04 [Rev 1.03.a]
Page 16 of 72
12-9-1-0013-3-1-61