Download user Manual

PART 2 . SECTION 5
Push down on the basket top and make sure it springs back. If it does
not move, you have either placed the basket in the bucket up side
down, or the spring assembly is not working correctly. Open up the nylon bucket strap and slide the bucket underneath making sure the top 2
bucket latches are centered and facing away from the backplate. Open
all 4 bucket latches and fold back the hooks, so they do not get caught
between the bucket and head.
Put your hand at the bottom of the bucket and push it up towards the
head, making sure not to twist or push at an angle.
WARNING: If you can’t inhale from the loop once you seal the
bucket on the head it’s most likely because you installed the
scrubber basket upside down in the bucket. The bucket spring
forces the flat basket top onto the Red CO2 Seal as a safety
precaution, stopping gas flow around the loop.
When the bucket is close enough to the head that the latches can catch
onto the Latch Keeper, flip the two side latches onto the keeper and lock
them in place. Verify that the latches are locked by attempting to pull
up on them. Then flip the middle latch into place and lock it down. Then
verify it is locked too. Look at the two O-rings through the clear bucket
to verify that they are in their grooves and are not twisted or pinched.
| 62