Download User Manual - Advanced Technology Services

PanelMate® ePro PS Family User Manual
December 2008
Warnings and Cautions
CAUTION
The USB ports are to be used for corrective maintenance only and
not for permanent use in Class I, Div 2 Groups A, B, C, D locations.
If permanent use is required in Class I, Div 2 Groups A, B, C, D
hazardous locations then UL approval must be obtained.
CAUTION
Make sure to turn off and/or disconnect power to the PanelMate
ePro PS unit before removing or inserting the CompactFlash
memory card, as the CompactFlash memory card should not be
hot-swapped. Failure to remove power before installing or
removing the CompactFlash memory card, can result in damage to
the CompactFlash and/or unit.
CAUTION
Before hot-swapping PCMCIA cards, verify the card being used is
specified to support hot-swapping.
CAUTION
Your PanelMate ePro PS unit is equipped with port isolation on
serial port 1 (COM1) only. Check for any ground potential difference
between your communication equipment and your PanelMate ePro
PS unit. If there is a ground potential difference, your
communication equipment will need to be isolated.
CAUTION
The CompactFlash card and any PCMCIA card must be removed
before removing the back cover of the unit.
CAUTION
Explosion hazard. Substitution of components may impair
suitability for Class I, Division 2.
ADVERTISSMENT
Risque d’explosion. La substitution de composants puet rendre ce
material inacceptable pour les emplacements de Classe I, Division 2.
WARNING
Explosion hazard. Do not replace components unless power has
been switched off or area is known to be non-hazardous.
ADVERTISSMENT
Risque d’explosion. Couper le courant ou s’assurer que
l’emplacement es designe non dangereux avant de replacer le
composants.
MN04801001E
ix