Download ModWorX Pro Software User Manual

Transcript
ModWorX Pro™
Section 11
8. Enter the viscosity of the measured fluid in the field provided. If you are unsure of the value, enter
0.010268.
9. Enter the isentropic exponent of the measured fluid in the field provided. If you are unsure of the value,
enter 1.3.
Note
Disregard the Gas Fraction field. This setting is not currently used in flow calculations.
10. To change the mole percentages of individual gas constituents,
a. Locate the gas constituent to be changed.
b. Double-click the constituent or click on the Change Mole % button and enter the appropriate
percentage in the dialog box provided.
c. Repeat steps 10a and 10b until all constituents are entered.
Note
When the AGA-8 Detail method is used, all constituent percentages entered must total 100%.
11. To load the current gas composition or a previously saved composition, click Load Composition… and
select the set of gas composition values from the dropdown menu in the dialog box provided. If only
minor changes are required to an existing composition, this can save time by minimizing the number of
constituents that have to be changed.
12. Enter a note in the Note field, if desired (for example, to identify the gas composition for future reference). The note will be stored with the gas composition settings.
13. Click Save Changes in the upper right corner of the screen. The changes will be saved as the Current Gas
Composition and will be put into effect when the user exits the Maintain Flow Run screen.
14. To perform a new maintenance task without leaving the screen, click on Change Task and make a new
selection.
15. To exit the Maintain Flow Run screen and return to the Main Display screen, click Exit Maintenance
Mode in the upper right corner of the screen.
Procedure: Change Gross Method Parameters
1. If Change Gross Method Parameters is not displayed in the Maintenance Task field at the top of the Maintain Flow Run screen, click on Change Task. The Change Flow Run Maintenance Task dialog box will
appear (Figure 11.9).
Figure 11.9
163