Download - Scientific Systems

2 INSTALLATION
2.1 Unpacking and Inspection
Prior to opening the shipping container, inspect it for damage or evidence of
mishandling. If it has been damaged or mishandled, notify the carrier before opening
the container. Once the container is opened, inspect the contents for damage. Any
damage should be reported to the carrier immediately. Save the shipping container.
Check the contents against the packing list.
2.2 Location/Environment
The preferred environment for the Ultra-High Pressure pump is normal laboratory
conditions. The area should be clean and have a stable temperature and humidity.
The instrument should be located on a stable flat surface with a minimum 4-inch
clearance on all sides for ventilation and the necessary electrical and fluid
connections. (Reference IEC 1010 installation category II, and Pollution degree 2
environment).
2.3 Fluid Connections & Priming
There are only three connections to be made:
1. Connect Pump solvent line supplied
2. Connect line to injection valve or autosampler from outlet
3. Connect the self flush inlet and outlet (opaque) tubing as shown on the the
next page, if this option is included with the pump.
Details on the proper installation of tubing and priming of the pump and self flush is
shown on the next page.
2-1