Download User Manual - Touch Dynamic

3.
4.
4-5
Thread two ends of the VGA cable respectively through the gaps on the 2nd
display and system stand as shown in the above picture.
When the VGA cable is routed through the stand gap, close the cable cover
and fasten the thumb screw. Finally connect the other end of the cable to
the system port.
Install the Cash Drawer
You can install a cash drawer through the cash drawer port. Please verify the pin
assignment before installation.
Cash Drawer Pin Assignment
Pin
1
2
3
4
5
6
Signal
GND
DOUT bit0
DIN bit0
12V / 19V
DOUT bit1
GND
Cash Drawer Controller Register
The Cash Drawer Controller use one I/O addresses to control the Cash Drawer.
15