Download ADAP Software Operating Manual
Transcript
2. Choose Start to begin reading the plate. When the measurement is complete, Plate-ID appears (Figure 6-19). ÎTo stop a measurement in progress before it completes, choose STOP Measurement. OR Choose Cancel to return to the ADAP software main screen without performing the measurement. Figure 6-19: Plate-ID 3. In Input Plate-ID, rename the plate, if desired. Î The default format of Plate-ID names is YYYYMMDD-N, where YYYY is the year, MM the month, DD the day, and N the number of the reading made that day. 4. Choose OK to save the measurement results to the database. 5. If using the Zenyth 340 absorbance detector, choose Eject Plate to move the plate carrier outside the instrument. Remove the measured microplate from the plate carrier and choose Load Plate to move the plate carrier inside the instrument. OR If using the Lucy 2/3 luminescence detector, manually remove the microplate from the instrument (refer to the instrument user’s manual for more information about removing microplates). 6-34 ADAP Software Operating Manual ADAP