Download EXPERT PN110

EXPERT PN110
20. The water counter must be calibrated to monitor the water consumption. Refer to section
5.16.8 to calibrate the water counter.
21. If a humidity probe is used, the user must adjust the humidity compensation to control the
level of humidity in the building. Refer to section 5.17.4 to set relative humidity options.
22. Setting the temperature curve (optional). The
user may configure a temperature curve to
automatically adjust the set point over a given
time period. Refer to section 5.17.2 to adjust
the temperature curve.
23. Setting the minimum ventilation curve (optional).
The user may configure a minimum ventilation
curve to automatically adjust the minimum ventilation over a given time period. Refer to section 5.17.3 to adjust the minimum ventilation
curve.
50
EXPERT PN110 rev.12
5.16.2 Setting Password
This function allows to identify 2 different user
types. It is used to restrict access to certain parameter settings. The password is made up of
three blocks of two digit numbers, for example:
13 44 21. When a correct password is entered,
the current user is identified.
Installer Password: By default, the INSTALLER
PASSWORD is set to "6-1-0". The installer mode
gives the access to all functions of the EXPERTPN110. By default, the controller returns to the
user mode after 15 minutes of inactivity. The installer may return to user mode before that delay
by entering the user password. The installer password can be modified.
User Password: The user mode gives access to the
basic functions of the EXPERT-PN110. By default
this password is set to "1-2-3". Note that some
menus will not be accessible on user mode. The
user password cannot be modified . The control
automatically returns to user mode after 15 minutes of inactivity.