Download Infinity Help - Berg Liquor Controls

Infinity Help
193
Set Up Sales Station for Interface
To set up a sales station for interface:
1. Pull down the Interface menu and click Sales Stations....
You will only see this menu option if you've allowed multiple drivers on the
Activate Drivers screen. Alternatively, you can select the Management |
Setup | Sales Stations menu option. This takes you to the same screen.
2. Select a Sales Station and click Modify....
OR
Click New... to set up a new sales station.
See Sales Station Setup for help creating a new station.
3. Verify the correct equipment displays in the Current Definition list for
the sales station.
Use the Add or Remove b uttons to makes any changes to the list.
4. Select the appropriate Driver for the sales station.
You'll see only the driver(s) you've activated in this list. You're selecting the
correct driver file for the sales terminal to which this sales station is
connected. If you've activated only one driver, it displays b y default. This
driver file will b e downloaded to all the ECUs you've included in this sales
station when you load driver.
5. Click OK to save the selected equipment and driver for the sales station.
6. If required, click OK to confirm the message about loading drivers to
ECUs. See Load Driver.
August 2010
Sales Stations
You must use Sales Stations to
indicate where each driver is to
be loaded.
By default, all ECUs and
dispensers are included in the
<Default Sales Station>. If
you remove any equipment from
this default sales station and do
not re-assign it to another sales
station, it will not be interfaced.
When Allowing Multiple Drivers,
sales stations indicate which
driver is being used by each
ECU.
For Dispenser network ECUs, if
there is more than one P3 Hub
on an ECU, an additional sales
station is required to specify the
association between each P3
Hub and the dispensers it
services,
Copyright © 2009-2010, Berg Company, LLC