Download LOOP-AM MODEL 3440-B Access DCS
Transcript
Chapter 12 Appendix F: Setting up an AM3440-B PDH Shared Protection Ring (T1) 5. FDL (Facilities Data Link) On the Port System Setup screen, set the FDL must be set at FDL and FRAME (must be ESF & T1.403) for all ports in the ring (ie. Slave unit ports and Master unit ports). This setting is highlighted on the sample setup screen below. SLOT 5 Quad-T1 PORT 1 === Port System Setup === ARROW KEYS: CURSOR MOVE, TAB: ROLL OPTIONS FRAME CODE YEL AIS CAS SIGNALLI= CGA OOS INBAND IDLE INTF LBO FDL Protected Master 10:35:03 03/06/2007 = ESF&T1.403 = B8ZS = ON = FRAMED = OFF TRANS = NORM = BUSY = OFF = FF = LONG HAUL = 0 dB = FDL = DISABLE = **** << Press ESC key to return to previous menu >> 6. TSI Function The TSI function for all the AM3440-B devices must be set at 1: N (Multicast). This setting is highlighted on the sample setup screen below. LOOP AM3440-B === System Setup (SYSTEM) === 15:46:03 03/24/2006 ARROW KEYS: CURSOR MOVE, Please Input: hh:mm:ss mm/dd/yyyy, BACKSPACE to edit [System] Time/Date : 15:46:04 03/24/2006 IP Address : 020.001.001.011 Subnet Mask : 255.255.000.000 Gateway IP : 020.001.001.001 IP Interface : HDLC_PORT [CONSOLE port] Baud Rate : Data Length : Stop Bit : Parity : XON_XOFF : Loopback Timer (s) : 00000001 38400 8-Bits 1-Bit NONE XOFF [TSI map] TSI Function : 1:N(Multicast) Idle Signaling: 1101 [Clock] Clock Mode : Normal << Press ESC key to return to previous menu >> 165