Download Zigbee User Manual - Pantech Solutions

must be connected to a serial port of a PC.
NOTE: Failure to enter AT Command Mode is most commonly due
to baud rate mismatch. The
interface data rate and parity settings of the serial port ("PC
Settings" tab) must match those of
the module (BD (Baud Rate) and NB (Parity) parameters
respectively).
Serial Communication Software
A terminal program is built into the X-CTU Software. Other
terminal programs such as "HyperTerminal" can also be used to configure modules and monitor
communications. When issuing AT Commands through a terminal
program interface, use the following syntax:
Figure . Syntax for sending AT Commands
Join the Technical Community Today!
http://www.pantechsolutions.net