Download "user manual"

HPUC0191 • HPUC0193
Descriptor code: F- A fatal error (cURL exits
immediately).
Automation: Not applicable.
user response is required. To suppress this
informational message, the user should remove "-v" or
"--verbose" options.
Problem determination: No additional information.
HPUC0191
Can't complete SOCKS5 connection to
IP_address:port. (resp_code)
Explanation: This message indicates that cURL failed
to connect to the SOCKS5 server.
IP_address
An IP address in the form n.n.n.n
port
Port
Example: HPUC0192 SOCKS4 request granted.
Source: cURL
Routing code: Not applicable.
Descriptor code: N- An informational notice. Could be
an error or could be normal behavior.
Automation: Not applicable.
resp_code
SOCKS5 server response code
System action: cURL immediately stops processing
and exits.
Operator response: No System Operator response is
required.
System programmer response: No System
Programmer response is required.
User response: Make sure that the SOCKS5 server is
functioning correctly. For more information, refer to
SOCKS Protocol Version 5 as defined by Network
Working Group RFC (Request for Comment) 1928. The
user should find the additional response code in this
message, this may require assistance from your
system's network administrator.
Problem determination: No additional information.
Module: Not applicable.
Example: HPUC0191 Can't complete SOCKS5
connection to 100.100.100.100:100. (4)
Source: cURL
Routing code: Not applicable.
Descriptor code: F- A fatal error (cURL exits
immediately).
Automation: Not applicable.
HPUC0192
Module: Not applicable.
SOCKS4 request granted.
Explanation: This is an informational message which
is only displayed when the -v or --verbose option is
specified. It indicates that cURL has successfully
connected to the SOCKS4 server.
System action: Displays the message and continues
processing.
Operator response: No System Operator response is
required.
System programmer response: No System
Programmer response is required.
HPUC0193
Operation too slow. Less than speed_limit
bytes/sec transfered the last speed
seconds
Explanation: This message is displayed when the
'--speed-limit' and '--speed-time' options are used and
cURL has determined that the transfer speed is lower
than the requested transfer speed. In this case, cURL
terminates the download. This problem may be due to
a data transfer performance problem with the network,
local server or remote server. It may also indicate that
the user has specified an unreasonably slow speed time
and limit combination.
speed_limit
Specified transfer speed limit
speed_time
Specified transfer speed time
System action: cURL immediately stops processing
and exits.
Operator response: No System Operator response is
required.
System programmer response: No System
Programmer response is required.
User response: Verify that the speed limits and time
were specified correctly and, if possible, determine that
the network, local server, and remote server are not
experiencing performance problems. Additionally,
larger speed limit and time values can be defined using
the '--speed-limit' and '--speed-time' options,
respectively. If the problem persists, the user may
require assistance from your system's network
administrator.
Problem determination: No additional information.
Module: Not applicable.
Example: HPUC0193 Operation too slow. Less than
3000 bytes/sec transfered the last 10 seconds
Source: cURL
Routing code: Not applicable.
User response: This does not indicate an error. No
Chapter 6. cURL messages
131