Download GSM-Control User Manual

Wonderware Finland & Baltics GSM-Control
differs from actual SMSC
phone number used by
your GSM provider.
ERR0105: Bad message received
120
Control configuration
“Settings”.
2) There is not good
enough signal from the
GSM network - in this
case temporarily
disconnection from
network can happen and
no SMS message can be
sent/received.
2) Check and if possible
improve the location of
GSM-modem antenna
(e.g. by using longer
antenna connection
cable). Check if antenna
connector is firmly
connected to GSMmodem.
Received SMS message does
not match with any of SMS
messages configured for
sender of message.
Do not send anymore to
GSM-Control such kind of
non-expected SMS
message.
Notes:
1. The ERR0105 is not
displayed (logged) if
received SMS message
does not belong to any of
Users configured.
2. As default, no response
is sent in case nonexpected SMS message
is received, but this can
be changed by
unselecting “Ignore Bad
Messages” (see
GSMCTRL Menu
Commands/Options/
Ignore Bad Messages
section upper in this
manual).
The value of DDE or OPC item is
replaced by (DDE_Failed) or
(OPC_Failed) in the text of
SMS message sent from GSMControl
The value of corresponding
DDE or OPC item (inserted
into configured Send
message) cannot be obtained
from DDE or OPC server
(most probably the DDE or
OPC server is shut-down).
Check and if necessary
restart the corresponding
DDE or OPC server.
The value of SQL field is
The corresponding SQL read
Check the configuration of
GSM-Control User Manual Ver. 4.x Rev 4.5
P067m45.docx