Download CNC-Calc v7 User Guide

Transcript
Tutorial Lathe 2 - Machining the Part
120
This will open the Roughing Turning pane to the left of the drawing area. Now insert the
values shown in the dialog below.

Comment: This comment will be shown in the final NCProgram. It is always good to include a comment in order to
distinguish the various operations in the final program.

Retract Point Z: This is the Z value to where the operation
will retract the tool after completion.

Retract Point X: This is the X value to where the operation
will retract the tool after completion.

Radial Min: This is the lower machining limit for the
operation in the X direction.

Radial Max: This is the upper machining limit for the
operation in the X direction.
The roughing operation works on a contour, and in order to generate a toolpath we must
select that contour. This is done by clicking on the contour as indicated in the picture
below.
When the selection is made the contour is selected until the end. This is OK for this
operation but we really do not want any work done on the leftmost face, so in order to
exclude this click the Back button once. This will deselect the leftmost face.
Now your drawing should look something like the one below.