Download USER`S MANUAL - Automatisation JRT

1st way:
•
To access register DM132 : « ELEVATOR & LCD SETTINGS ELEVATOR
OPTIONS ENCODER/ BAR CODE / PERFOR. TAPE
DECEL
DISTANCE SPD <= 225FPM ».
•
If the slowdown distance in DM132 is 82: 82 x 0,75in = 61½ in
Therefore, the limits should engage slightly closer to the final terminal landing that
is, approximately 61 inches before the landing.
2nd way:
•
To access register DM132 : « ELEVATOR & LCD SETTINGS ELEVATOR
OPTIONS ENCODER/ BAR CODE / PERFOR. TAPE
DECEL
DISTANCE SPD <= 225FPM ».
• LRH adjustment: Place the car to the top terminal landing equal to the floor
(DZO activated, LU and LD deactivated). Write down the number of counts
displayed in the LCD screen “P” (ex. 500 counts). Subtract the value in DM132
(ex: 82 counts). Add one count to the result and this will give the position of the
normal slowdown limit "LRH".
Example:
P = 500 counts
Slowdown distance in DM132 = 82 counts
500-82 =418 counts
418+1count = 419 counts, position of the slowdown limit "LRH"
• LRB adjustment: Place the car at the bottom floor equal to the floor (DZO
activated, LU, and LD deactivated). Write down the number of counts displayed
in the LCD screen “P” (ex. 10 counts). To this value, you must add DM132 and
after, subtract 1. The result will give the position of the slowdown limits "LRB".
Example:
10 counts
Slowdown distance in DM132 = 82 counts
10+82 =92 counts
92-1count = 91 counts, position of the slowdown limit "LRB"
SLH and SLB limits position:
• Installed SLB and SLH limits at 24 inches from the floor approximatively. Install
SLB at 24 inches from bottom landing. Install SLH at 24 inches from top landing.
9-14