Download ASAS (Non-Linear)

ASAS (Non-Linear) User Manual
Loading Data
inode
: node increment to be added each time the data is generated by the RP command. (Integer)
RRP
: keyword to indicate data generation from the previous // symbol
nrrep
: number of times the data is to be generated. (Integer)
iinode
: node increment to be added each time the data is generated by the RRP command. (Integer)
END
: compulsory keyword to denote the end of the face temperature data block
Notes
1.
The position of Face 1 and Face 2 for each element is defined in the element description sheets in
Appendix -A.
2.
Since face temperatures are applied to all elements attached to the given nodes within the specified group,
care must be taken to ensure the consistent use of local axes on adjacent elements.
3.
Loading due to temperature and face temperature are additive.
4.
Nodal and element face temperature data must not be present in the same load set
5.
Notes for temperature data also apply here.
6.
If the material properties are temperature dependent, temperature load, if specified, must be present in all
of the runs (i.e. initial and restarts). If any run does not have face temperature load, then the reference
temperature should be specified as the top and bottom surface temperatures in the data.
5.4.8.2 ELEMENT FACE TEMPERATURE Data
To define uniform or varying face temperatures on elements. See Section 5.4.8.3 for details of uniform element
face temperature data and Section 5.4.8.4 for non-uniform element face temperature data.
Contains proprietary and confidential information of ANSYS, Inc. and its subsidiaries and affiliates.
Page 5-192