Download LSMP2 User Manual

Transcript
ComDeC
LSPM2
4.6 PROFIBUS DP interface
Transmission is performed in operating mode RS485 (RS485 physical).
Der LSPM2 hat hierfür folgende Pins:
Signal name
I/O
Type
RTS
TXD
RXD
XCTS
O
O
I
O
CMOS
CMOS
CMOS
CMOS
Function
Request to Send
Transmit data
Receive data
Clear to Send
Before sending, the LSPM2 sets the RTS signal to "1" and then loads the transmit buffer of the UART with
the 1st character. The UART delays the first telegram character until signal CTS is active. CTS is no longer
polled during telegram transmission. On completion of transmission (buffer empty stop bit is send), the RTS
is reset. The XCTS pin must be set to log.<0> during operation.
Switching times:
No.
Symbol
Parameter
1
TsRTS (TXD) RTS ↑ to TXD (Setup-Time)
2
ThRTS (TXD) RTS ↓ to TXD (Hold-Time)
*: 1 Tbit = 104µs at 9,6kBd, 1 TBit = 83ns at 12MBd
min.
Unit
2
2
TBit*
TBit*
Timing:
RTS
2
1
TXD
Attention:
At Power on is it possible that the RTS signal is a short moment high. You must consider this in your
application (see circuit diagramm).
Page 22
10/2002
Release V2.0
User Description
Copyright (C) Siemens AG 2002. All rights reserved.