Download Well Optimization Manager User Manual

Transcript
Well Optimization Manager Program User Manual (FB107+ROC800)
Well Optimization has four major functional “clusters”:

Configuration
Provides a single location for the configuration of all the program
features. Once you select the features you situation requires, the
program streamlines itself by concealing features which you have not
selected. Of course, you can re-select features to configure as your
wellpad situation evolves.

Well Core Operate
Provides a summary overview of vital well statistics, including
flowrates, pressures, averages, and a wealth of other information to
help you proactively monitor your wellpad.

Gas Lift Operate
Displays both current and historical gas lift operation and enables you
to adjust the routines in use. If your well does not require gas lift
enhancements, you can conceal this function until that time occurs.

Cyclic Operate
Monitors and manages all forms of “cyclic” (on-off style behavior)
control, such as plunger lift and intermitters.
Refer to the individual sections in this manual for further information.
Caution
The Well Optimization Manager program provides a watchdog timer
parameter that validates the execution of the application. This parameter
is a counter that increments by 1 at the beginning of each program cycle.
If the program stops, this read-only parameter stays at a fixed value and
does not update. Optionally, you can configure an external system (such
as an FST or SCADA) to monitor this watchdog timer parameter. If the
parameter stops updating, an external system triggers an alarm, which
allows you to take appropriate corrective action. On the ROC800, the
watchdog time parameter is TLP 65,0,224; on the FB107, it is TLP
178,0,224.
1.2.1 Definition of Terms
The following are the terms you may encounter when you configure and
use the Well Optimization Manager program.
Issued May 15
Term
Application
Definition
Afterflow
Cyclic Control
A plunger lift stage where the
well flows after arrival. The well
is open at this state.
Annulus
General
Refers to the area or space
between the well casing and
tubing.
3