Download Well Optimization Manager User Manual
Transcript
Well Optimization Manager Program User Manual (FB107+ROC800) Well Optimization has four major functional “clusters”: Configuration Provides a single location for the configuration of all the program features. Once you select the features you situation requires, the program streamlines itself by concealing features which you have not selected. Of course, you can re-select features to configure as your wellpad situation evolves. Well Core Operate Provides a summary overview of vital well statistics, including flowrates, pressures, averages, and a wealth of other information to help you proactively monitor your wellpad. Gas Lift Operate Displays both current and historical gas lift operation and enables you to adjust the routines in use. If your well does not require gas lift enhancements, you can conceal this function until that time occurs. Cyclic Operate Monitors and manages all forms of “cyclic” (on-off style behavior) control, such as plunger lift and intermitters. Refer to the individual sections in this manual for further information. Caution The Well Optimization Manager program provides a watchdog timer parameter that validates the execution of the application. This parameter is a counter that increments by 1 at the beginning of each program cycle. If the program stops, this read-only parameter stays at a fixed value and does not update. Optionally, you can configure an external system (such as an FST or SCADA) to monitor this watchdog timer parameter. If the parameter stops updating, an external system triggers an alarm, which allows you to take appropriate corrective action. On the ROC800, the watchdog time parameter is TLP 65,0,224; on the FB107, it is TLP 178,0,224. 1.2.1 Definition of Terms The following are the terms you may encounter when you configure and use the Well Optimization Manager program. Issued May 15 Term Application Definition Afterflow Cyclic Control A plunger lift stage where the well flows after arrival. The well is open at this state. Annulus General Refers to the area or space between the well casing and tubing. 3