Download User`s Manual

Transcript
Drive Installation
We recommend that you have the drives installed, formatted and tested by Fast Forward
Video. However, you may install the drives by following the procedure below. We ONLY
recommend specific hard drives - see http://www.ffv.com/page/support.htm for part numbers. These specific drives have been tested with the HD3, and proven to have the best
performance and reliability.
2.5” Drive Removal/Replacement Procedure:
6
1.
On the side of the HD3 push black button drive release.
2.
To install a drive remove the two screws from the rear panel of the drive enclosure.
3.
Remove the circuit board from the drive enclosure.
4.
Attach the 2.5” SATA hard drive to the circuit board, and fasten it to the board using
drive mounting screws.
5.
Once the hard drive has been secured on the circuit board, replace the circuit board
(with hard drive attached) in the drive enclosure (drive facing up). Fasten the rear
panel of the drive enclosure, using the screws that were removed in step #3.
6.
Slide the drive back into the enclosure bay.
HD3 Manual, Fast Forward Video, Inc