Download User Manual

Transcript
Chapter 5—System Configuration and Operation
Contactor Feeder Operation Mode
The Contactor Feeder operation mode accepts open/close
commands to control the contactor in a feeder application.
Recommended User Interface Overlays for the
Contactor Feeder Operating Mode
Figure 137. C445UC-I7: IEC Control and Status
A close command will activate Output 1. An open command
will de-activate Output 1.
C445 Feedback Signal Source Selector parameter.
Input source of the feedback signals:
●
0 – No feedback source
●
1 – User interface inputs (In#2 – aux on)
●
2 – Base control inputs (In#2 – aux on)
●
3 – Fieldbus parameter (2nd bit – aux on)
Figure 138. C445UC-I8: IEC Control and Status
The C445 will issue a control fault when:
●
An Open command active and the Aux On feedback input
is true.
●
Current is detected after an open command.
●
A Close command is active and the Aux On feedback input
is false.
When the C445 experiences a fault/inhibit condition Output 1
will be de-activated to open the feeder.
●
Output 1 – feeder contactor coil (NO)
●
Outputs 2 and 3 – open for user configuration and their
function can be selected by the user.
Figure 139. C445UC-N7: NEMA Control and Status
Figure 136. Timing Diagram for the Contactor Feeder
Operating Mode
Timing Diagram
Control Fault delay
CLOSE
Figure 140. C445UC-N8: NEMA Control and Status
OPEN
122
Power Xpert C445 Global Motor Management Relay MN042003EN—September 2015
www.eaton.com