Download Chapter 1 EasyBuilder Pro Installation and Setup Guide

Transcript
Object

HMI will not regularly read the data from [Action mode] (address + 2) to [End time]
(address + 10). Please turn [Control] ON when the settings are changed.
b. Status (Time setting address + 1)
When the read operation above completes bit0 of this register truns ON. If time data read
is out of range or incorrect in any way bit1 turns ON..
15
02 01 00
Bit
0
Reserved (0 fixed)
0
Bit 00: Status bit: Read operation completed. (0: reading or reading not started. 1:
reading completed.)
Bit 01: Error bit: Start or end time format incorrect. (0: corrected 1: error)

After the scheduler reads the data and the status is turned ON (The value in [Address +
1] = 01), the control bit must be turned OFF (address = 0). The status bit and error bit
will be turned OFF (10) at the same time.
302